Capo at Fret 4

Four frets to B, the singer’s capo. High enough that the neck starts feeling short and the drone starts wanting attention of its own.

A neck capo at fret 4 raises the four neck strings by 4 semitones and leaves the short fifth string exactly where it was. That asymmetry is the whole subject: on a guitar a capo is one action, and on a five-string banjo it is two.

What it gives you

The open strings spell G with no capo, so at fret 4 the same system sounds in B. Nothing about your left hand changes — the shapes are the shapes, and only their names move:

G → B, C → E, D → F#, Em → G#m, Am → C#m

The fifth string

The fifth string's nut sits at fret 5, not at the nut proper — the string is short and starts partway up the neck. So to raise it by the same 4 semitones, the spike or fifth-string capo goes at fret 9, which is 5 further along than the neck capo. The drone then sounds B instead of G.

Capo at fret 4 — the neck strings, derived
StringOpenCapoed
4DF#
3GB
2BD#
1DF#

Doing it

Capo the neck first, then the fifth string, then retune — clamping a banjo neck almost always pulls something sharp, and a drone that is a few cents out is audible immediately because it never stops sounding. Check with the tuner before you play a note.

Your rolls are unaffected: a capo transposes the whole system and leaves the right hand identical, which is exactly the argument for capoing rather than retuning when all you want is a different key.